BROADENING THE HORIZON IN TECHNOLOGIES
AND EQUIPMENT FOR THE FILM AND TELEVISION INDUSTRY

 
FiberAnt

FiberAnt


The Fiber Ant is a unique devise that carries RF on fiber. It was designed specifically for audio RF antennas and GMS Microwave block down convertors. FiberAnt works with any RF signal from 48MHz to 2.4GHz and has a loss of less than 3 dbm over 5 miles of single mode fiber cable. Typically an RF audio antenna can only be 125 ft from its receiver and in GMS systems, the BDC antenna is no more than 350ft from the receivers. When you plug in an antenna into the F.A. you greatly increase the distance you can go from the receiver.

If for instance, your RFmics or RF cameras are playing in a large area and you need to have antennas further away to get good signals.


You can leave the receivers where they are and using a FiberAnt system put your antennas 100ft to 5 miles away. This can give you unlimited area coverage. The FiberAnt also has a built in 12 Vdc BiasT  that allows you to power an active antenna ,GMS BDC , or any other receive antenna that requires 12Vdc. This system will work with wireless PL system as well.


  1. Frequency: 48MHz to 2.4 GHz

  2. Input power: 12Vdc

  3. Single mode fiber

  4. Distance: 10 miles

  5. RF input: 40dbm max

  6. RF conn. BNC

  7. Fiber conn. ST



Specs

2010. SkyDreams Technologies. All rights reserved.

SkyDreams Technologies, INC
FiberAnt
FiberAnt
FiberAnt
FiberAnt
FiberAnt

Additional Photos